Harvard retuning after maiden

[Kevin Rochon]

This is going to be a short thread.

I need some weight in the right wing for the balance as I needed a lot of trim to correct. So tonight I applied some epoxy to the rib so I can stick on the lead.

I also ordered 2 Falcon props 22 x 10 white with red tips from Thunderbolt RC.

[Kevin Rochon]

So got my props today from Thunderbolt RC. I also got 50' of servo wire and Futaba connectors to make my own extensions for my next project:confused:
Balanced one my usual way using clear spray for the horizontal balance then nails for the hub balance. The 2 nails sticking out goes through the spinner plate and in the engine hub.

Since I had my spinner cut out for an Xoar prop but couldn't find any I had to modify the slots as the Falcon props are thicker, even then the Zinger, and wider. So now the prop matches the plane...hope they both last:rolleyes: