stephane.savard
2008-06-28, 06:01 PM
My coroplast MiG-3 combat plane (black & green camoflage scheme) is up for grabs to anyone that wants to get into combat.
A few disclaimers.
First, this plane is in need of minor repairs. The servo tray needs to be put back together with some glue (household goop would be best). It's an easy repair.
Second, only seasoned fliers need apply. This plane has got some bad habits, and you'll need to be careful while flying it. But it DOES fly.
Third, it needs hardware. Here's a complete list:
2x standard servos.
2x 2-56 pushrods (about 6 inches each), with clevises (for ailerons)
2x 4-40 Dubro horn brackets (http://www.greathobbies.com/productinfo/?prod_id=DUB557)
2x Hitec HS-81 servos (or similar with the same footprint)
Receiver
Standard switch harness
Battery
6ox Dubro fuel tank
Dave Brown 2025 Engine mount (will need to be slightly modified, I'll show you how)
OS 25fx engine.
4x 4-40 3/4" bolts with lock washers and washers.
Spinner.
9x4 master airscrew prop.
Bascially, this is what I took out of the plane, so if you want to change it around, you're on your own.
This is free to the first person that speaks up in this thread, but understand that it is not the best flier, tip-stalls fairly easily, and at very high speed has trouble rolling left. Though if someone has enough patience, they might be able to get it flying better.
Enjoy!
A few disclaimers.
First, this plane is in need of minor repairs. The servo tray needs to be put back together with some glue (household goop would be best). It's an easy repair.
Second, only seasoned fliers need apply. This plane has got some bad habits, and you'll need to be careful while flying it. But it DOES fly.
Third, it needs hardware. Here's a complete list:
2x standard servos.
2x 2-56 pushrods (about 6 inches each), with clevises (for ailerons)
2x 4-40 Dubro horn brackets (http://www.greathobbies.com/productinfo/?prod_id=DUB557)
2x Hitec HS-81 servos (or similar with the same footprint)
Receiver
Standard switch harness
Battery
6ox Dubro fuel tank
Dave Brown 2025 Engine mount (will need to be slightly modified, I'll show you how)
OS 25fx engine.
4x 4-40 3/4" bolts with lock washers and washers.
Spinner.
9x4 master airscrew prop.
Bascially, this is what I took out of the plane, so if you want to change it around, you're on your own.
This is free to the first person that speaks up in this thread, but understand that it is not the best flier, tip-stalls fairly easily, and at very high speed has trouble rolling left. Though if someone has enough patience, they might be able to get it flying better.
Enjoy!